[maemo-developers] 答复: 答复: [maemo-developers] question of resolution

[From: Ziqi He]

I tried to run Xephyr on 'display:1' by using following commands:
#export DISPLAY=127.0.0.1:1
#af-sb-init.sh start
but failed.
Is that correct?
And how can I run Xephyr on 'display:1'?

xrandr -d :1 -s 320x240+0+0
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~How and where I should use it?

ext Ziqi He wrote:
> The command I have used is #export DISPLAY=127.0.0.1:2,
>  So I think that my Xephyr is running on display ':2'
> How can I change resolution of Maemo (not the size of Xephyr)?
> Thanks
>
>   
The size of the 'Maemo environment' is specified by the X and in this
case it is Xephyr. As you can see (if you tried xrandr) our program UI's
are not so scalable to such small sizes as 320x240. However, there is
scalability work going on to make it more scalable, feel free to post
ideas,comments :

http://maemo.org/maemowiki/MaemoScalability


> Best regards
>
> Ziqi He
>
>   

// Tapani

> ext Ziqi He wrote:
>   
>> Hi all,
>> How can I change the resolution of Maemo to 320x240 in scratchbox.
>> My LCD device must work in this resolution. Thanks a lot.
>>
>>   
>>     
> If you have Xephyr running on display ':1', you can change it's screen
> dimensions using xrandr like this :
>
> xrandr -d :1 -s 320x240+0+0
>
>   
>> Best regards
>>
>> Ziqi He
>>
>> _______________________________________________
>> maemo-developers mailing list
>> maemo-developers at maemo.org
>> https://maemo.org/mailman/listinfo/maemo-developers
>>
>>   
>>     
>
> // Tapani
>
> _______________________________________________
> maemo-developers mailing list
> maemo-developers at maemo.org
> https://maemo.org/mailman/listinfo/maemo-developers
>
>
>